|
If it happens with anything you plug into those ports, then it sounds like you've either got a short in the cables between the ports on the case and the motherboard, or you've got a bad motherboard.
|
|
|
|
|
Looks like ESD (ElectroStatic Discharge).
|
|
|
|
|
To the downvoters:
thanks a lot for your downvotes.
A few years ago, I worked for a manufacturer of USB devices. Problems with electrostatic discharges were very common for that manufacturer. Consequently, I have seen many effects of such discharges.
Discharges often occur when someone plugs-in the device, but they can also occur later on. They occur more often during winter, when the offices are heated and thus the air is very dry.
In my opinion, the downvoters provided proof of their lack of knowledge, though they are high-ranking CP members.
Thanks in advance for downvoting this message.
|
|
|
|
|
You havent booted into denug mode have you?
Anyway, whats the OS, whats the device, are there upgraded drivers (because thats whats doing it).
Can you boot into debug mode and attach a kernel debugger to it and find the stalled thread?
==============================
Nothing to say.
|
|
|
|
|
It's windoze xp professional. It doesn't matter what device it is, it only happens at random. I can plug the usb drive in 19 times, and one of those times the screen goes black. Likewise I can plug in the e-cig many times, and one random time it will have the same effect.
I don't think it has much to do with the drivers. I'm leaning towards the short.
If it moves, compile it
|
|
|
|
|
I think it's probably a short too... the leads in USB are relatively close together. If the connector is damaged, it's easy for them to touch one another.
|
|
|
|
|
I would be very surprised. The USB plug is pretty crude, and it happens with lots of devices, only with his front panel conectors.
Thats says its a particular UHCI driver or eben a UHCI chip that is misbehaving and causing system driver to mess up.
I have worked a lot with USB in the kernel, you would be surprised what plugging a device a thousand times can do to a system eventually.
==============================
Nothing to say.
|
|
|
|
|
Erudite_Eric wrote: The USB plug is pretty crude
I mention the short because the same thing happened to my desktop. I accidentally broke the plastic portion when I pulled sideways on a thumb drive (it was stuck on my shirt). The plastic piece broke and the leads were left behind, so if I forget and plug something into that port it causes a short.
Drivers can cause the same types of issues, but the most common is the all dreaded blue screen of death. I guess he has to cover the basis to find out what's really wrong.
|
|
|
|
|
Yes,, drivers BSOD, but if they have an endles wait or dealock that will lock the machined up, and those can be quite common driver faults too.
Verifier will tell you if a driver is making those kinds of errors.
==============================
Nothing to say.
|
|
|
|
|
loctrice wrote: I don't think it has much to do with the drivers
Dxont believe it. A driver can fail very very randomly. It all depends on what memory id over written and what tries to use that memory.
If you like, ie, its a good idea, run Verifier (type Verifier at a command prompt) and check each USB driver on the syste, in turn. Select all but low resource simulation.
What it will do is check a driver very thouroughly and BSOD the machine with a usefull dump. (Have the machine set up to create full kernel dumps).
THen open the dump, mempry.dmp, in windbg and see what it says (need to type analyse -v in the command line at the bvottom of windb after it has loaded the dmp file)
It is very good verifier. If you have a driver issue, it will find it.
==============================
Nothing to say.
|
|
|
|
|
Have you looked at Event Viewer?
|
|
|
|
|
hi, i'm new in using wireless usb modem and i got a few question
1. is that true EVDO is faster than HSPA? if no, which one is better?
2. is that true HSPA modem is stabler than EVDO and that makes gaming don't lag?
3. if i use the same ISP (same internet price) using 14.4MB modem and 7.2MB modem, is that true 14.4MB is faster?
i've searched in google about this and found mostly blogs advertising ISP. 
sorry for bad english but thankyou for reading..
modified 28-Feb-12 21:17pm.
|
|
|
|
|
i Would say check the signal level of the network provider. By hardware both HSPDA and EVDO are good . But signal level depends on the area u r using the device. I use EVDO , Personally i feel it good. Go by the network signal in the area u r using it....Not by the rates or hardware.
All the best .
|
|
|
|
|
so hardware doesn't affect the speed or ping?
thankyou very much.. 
|
|
|
|
|
My Dell Inspiron 1525 will Power Off without warning at battery end.
I did a regular windows (7) update at the weekend, and I had the instinct that it would not end well when I saw all the chkdsk stuff scrolling up.
I was correct, now when the battery reaches end of charge, it terminates without warning loosing any unsaved work.
I have been through the power options but I cannot see what I need to reset.
I have also recently installed Winzip Utilities suite to help manage the machine.
Note Malaware anti Malware has caused unexpected shutdowns at a point in its process for over a year now. Discussions here lead to a consensus that there is probably a bad sector in the disk, althouth none is being detected. This may be a factor - but this latest problem is definately confined to the end of the charge.
All thoughts and suggestions greatly appreciated.
Ger
|
|
|
|
|
Ger Hayden wrote: I have been through the power options but I cannot see what I need to reset.
Control Panel -> Power Options, click the "Change plan settings" link on the current selection. Click "Change advance power settings" on the next page, scroll down the list box in the popup and check the settings for battery levels and notification.
Unrequited desire is character building. OriginalGriff
I'm sitting here giving you a standing ovation - Len Goodman
|
|
|
|
|
Critical battery action is hibernate.
Ger
|
|
|
|
|
I know, but you also use that dialog to set the alarm points so it should warn you at certain intervals when battery power is low. On my Windows 7 machine there is an entry: Low Battery notification: On.
Unrequited desire is character building. OriginalGriff
I'm sitting here giving you a standing ovation - Len Goodman
|
|
|
|
|
Hi Richard,
All warning in order. System still thinks theres 20% plus power available when it stops. The battery is over 2 years old. I recently used Winzip utilities to boost the system performance and I think the battery has gone 'off the cliff'. It gets used on the battery for about 90 mins twice a day three days a week. This week its been delivering about 50 minutes. It varies. The last night it performed well was when I was doing a very intensive database reorg.
It might be time for another replacement. In 12 years of using laptops the batteries have typically lasted no more than 2 years...
Ger
|
|
|
|
|
Ger Hayden wrote: System still thinks theres 20% plus power available when it stops.
Definitely sounds like a bad battery.
Unrequited desire is character building. OriginalGriff
I'm sitting here giving you a standing ovation - Len Goodman
|
|
|
|
|
One on order from yesterday.
Now that I know its crapping out early I am saving my work with obsessive regularity, and all that extra disk activity is eating up the power even quicker. But it did still manage 70 minutes this morning...
Ger
|
|
|
|
|
I hope this is the right forum for this question.
I need a generic NIC driver that upon installation will allow the host computer connect to a network so that the correct driver for the NIC can be found from our driver library and installed. So is there such a beast out there?
|
|
|
|
|
You can onnly have a generic driver for a NIC if you have generic HW (in the same way UARTs all use the same register layout and command set). NICs dont, so the answer is no I am afraid.
==============================
Nothing to say.
|
|
|
|
|
Damn, I had a feeling that might be the answer  
|
|
|
|
|
Yeah, there isnt much standardisati8on in HW at that level, ie directly touching IO ports.
You will have to preinstall all the various NIC drivers on each machine. SHouldnt be too hard, just a script or simple program to run the inf files.
==============================
Nothing to say.
|
|
|
|
General 
News 
Suggestion 
Question 
Bug 
Answer 
Joke 
Praise 
Rant 
Admin 
Submit an article or tip
