Welcome to the Lounge

PIEBALDconsult30-Apr-23 9:08

PIEBALDconsult

30-Apr-23 9:08

This is the way.

Mircea Neacsu30-Apr-23 9:31

Mircea Neacsu

30-Apr-23 9:31

In my recipe, the final connection (and the spark) is the negative on donor. Presumably a good battery is not emitting that many fumes and all should be good. Personally I don't like looking for unpainted metal: you never know how good the contact is. I prefer battery posts or jump-starting posts for cars that have the battery in the trunk.

Mircea

FreedMalloc30-Apr-23 10:02

FreedMalloc

30-Apr-23 10:02

I had a truck once whose battery was nearly inaccessible. It had separate jump posts. Fortunately I only needed them once, but it sure was nice they existed then.

I understand why the donor is turned off until ready to jump start but personally I've never done it that way. I've always just left the donor running. And, I've never understood why all the advice is to do it in the order I gave. The net and manuals just give that order with no explanation. I've just blindly followed the expert's advise. Perhaps I'd better stay away from those TikTok challenges. Big Grin | :-D

I have run into cases where the unpainted connection wasn't well enough grounded to work - quite frustrating. In all actuality, when I've had to jump a dead car it was usually outside, -20F, and the wind was howling like a banshee at Mach 7. Any fumes from that dead battery are a half mile away from where I needed to worry them. Under those conditions expediency, safe or not, meant directly connecting to the battery anyway.

Nelek30-Apr-23 11:38

30-Apr-23 11:38

with relative new cars don't need to search for them, there should be a bold / stud in the near of the battery that is to be used as ground.

M.D.V.

If something has a solution... Why do we have to worry about?. If it has no solution... For what reason do we have to worry about?
Help me to understand what I'm saying, and I'll explain it better to you
Rating helpful answers is nice, but saying thanks can be even nicer.

obermd30-Apr-23 11:10

obermd

30-Apr-23 11:10

Connect the negative first to get both vehicles to the same ground level. Disconnect negative last for the same reason.

Nelek30-Apr-23 11:35

30-Apr-23 11:35

obermd wrote:
Connect the negative first to get both vehicles to the same ground level.

I used to think the same but all the manual instructions of chargers and cables I have seen say to connect first the "+"

M.D.V.

Mircea Neacsu30-Apr-23 13:01

Mircea Neacsu

30-Apr-23 13:01

Unfortunately I'm not very good explaining things but I'll give it a try. I apologize before hand if I fail.

Here is my list of steps with explanations why it has to be done in that order.

1. connect positive lead on donor.
The only danger is if the other end of the jumper wire touches the body of the donor car. To avoid that, keep both ends of the positive (red) jumper in your hands.

2. connect positive lead on receiver
Nothing can go wrong. The receiver car body is not connected to the donor so there is no chance of a spark. You are by the receiver car now so you can proceed to step 3.

3. connect negative lead on receiver
Still nothing can go wrong. The other end of the negative (black) jumper is not connected.

4. connect negative lead on donor
Some sparking may/will occur. However you are at the donor car and the good battery will not produce much fumes.

5. start donor
You don't want to discharge the donor battery. If the engine is running the donor alternator will charge both batteries.

6. rev donor up to 1200-1500
Again you want as much help as you can get from the alternator. Revving up the donor engine will give you more juice. If receiver is very low, you can wait a few minutes at this stage to minimally charge the receiver battery. In cold whether, the charging process will also warm a bit the receiver battery and increase it's capacity.

7. try to start receiver
Don't do long tries. Pause 30 sec - 1 min between tries. That gives times to donor alternator to charge the receiver battery.

Disconnect in reverse order for the same reasons.

Mircea

englebart30-Apr-23 15:25

englebart

30-Apr-23 15:25

If you have a new car, read your owners manual first.

And if asked by dealership “did you use jumper cables” either as donor or receiver, act like you are hard of hearing so you do not void your warranty by admitting it!

jmaida30-Apr-23 16:20

jmaida

30-Apr-23 16:20

I have 2 cars and 1 truck. I keep rechargeable lithium jump boxes in each. They keep enough charge to work for quite awhile (I have not had one fail for lack of keeping a charge, in fact I have the same one work twice without a recharge). They each have small jumper cables which are very safe to attach. Once attached, power it on and then start your car. Has worked for all 3 vehicles in the 3+ years I have had them. If they don't then you can look for a donor car. Not exactly cheap, but worth it to not need a donor car. We have hot summers but does not an effect on them). Don't know about cold weather. I do know you want to charge them in ambient conditions. They charge with USB cable adapter in AC outlet. They could probably be charged from inside the car with USB port to 12VDC adapter.
NEXPOW Car Jump Starter, 1500A Peak

"A little time, a little trouble, your better day"
Badfinger

snorkie1-May-23 2:29

snorkie

1-May-23 2:29

100% agree with the jump pack. I have a RAV4 Hybrid with some jinky software that drained the 12V when off in the early days (OTA updates fixed it eventually). The jump pack keeps me from having to find a donor when it randomly decides to stop. I've even jumped a full size pickup from it.

Hogan

jmaida1-May-23 8:42

jmaida

1-May-23 8:42

last year I had 2 batteries (1 for car and 1 for truck) go bad the same day. what are the odds. They would not hold a charge. Jump packs came to rescue. I bought them both at the same time and still had some refund credits. (3 year warranty). Turns out they came from same batch of batteries from manufacturer. Some sort of factory defect no doubt.

"A little time, a little trouble, your better day"
Badfinger

Peter Adam30-Apr-23 20:20

Peter Adam

30-Apr-23 20:20

No one wants to hold the end of the cable while it is reeled up by the engine cooler fan of the donor car.

PhilipOakley1-May-23 0:54

PhilipOakley

1-May-23 0:54

There is no perfectly 'right' answer, and it depends on the state and type of the two car batteries, and the quality/capability of the alternator on the 'better' vehicle.

Historically, the main issue was that the alternator diodes would 'blow' during the jump-start if the donor car was running. The surge current into the dead car's starter was too high, especially with good jump-lead connections.

You also need the donor car and it's battery to have enough capacity when the two vehicles are initially connected (both vehicles off, mediocre donor trying to feed large dead battery could result in two nearly dead batteries, sigh).

Then there a lot of 'safety' choices as to which leads to connect securely first, and what happens when a lead slips, hence it's normal to connect the two chassis last (little chance of failure and short circuit at this stage, compared to slipping of the power terminal).

That said, on larger modern vehicles the alternator diodes now have good capacity (see articles/ videos [e.g. merlin's garage] on using them as welders!) so blowing the diodes on those beasts is less likely.

Finally, just because there's a lovely big terminal next to the battery's negative, doesn't mean it is actually a secondary chassis connection. On my car it's the common point for the positive connections - Oops.

Ed Kautz1-May-23 5:16

Ed Kautz

1-May-23 5:16

I miss manual transmissions:
1) Get in the car, turn the key to On.
2) Push in the clutch, put the car in gear.
2) Have friends push your car.
3) Let clutch out to engage transmission, engine turns over and starts.

Nelek1-May-23 11:26

1-May-23 11:26

That only works if the car DOES HAVE a clutch... nowadays is not granted anymore

M.D.V.

trønderen1-May-23 16:35

1-May-23 16:35

On manual transmission cars?

Well, I can easily see that you could replace the mechanical speed stick with, say, a pushbutton panel giving input to some microprocessor managed clutch and gearbox movements. I just haven't seen it yet.

I wouldn't want it, though! I've been driving so much on (very) slippery ice that I demand a mechanism that sets the wheels free rolling so I can regain control over the car when it has lost the grip. (If your automatically controlled shift has an option for that, then you do have a clutch, perfectly usable for the purpose discussed here. It just has a user interface different from a pedal.)

Nelek2-May-23 1:58

2-May-23 1:58

Automatic has "N" (Neutral), but it still is not the same.
In most (if not all) automatic shift, you have to press the brake in order to be able to change to "R" (reverse) or "D" (forwards). And in the moment you press the brake, then most of the effords of your pals pushing the car get wiped.

M.D.V.

trønderen2-May-23 3:44

2-May-23 3:44

Sure, cars with automatic transmission don't have a clutch. They never had!

Ed Kautz, who I responded to, started his post saying "I miss manual transmissions:". It is certainly true that far more cars have automatic transmission nowadays - that is exactly what he is bemoaning.

I did own an automatic transmission car for a few years, a rather strange one, a DAF66 with "variomatic" continuous variable transmission. Nice in summer, terrible in winter with slippery roads (even with studded tires). I decided never more to buy a car without a clutch (or another mechanism for setting the wheels free-running when skidding).

jschell2-May-23 11:36

jschell

2-May-23 11:36

trønderen wrote:
I wouldn't want it, though!

I know some construction workers and for years they would agree with that but more recently...

"Things to Consider When Purchasing New Dump Trucks[^]

"The automatic transmission eliminates the wear and tear of the clutch of the manual and automated transmission, and it is the easiest to drive, making it less fatiguing for the driver or operator. It also allows the driver to keep their eyes on the road and hands on the steering wheel, increasing safety. Additionally, the automatic transmission actually increases the engine torque in first gear to make the truck perform better when operating off-road and in soft soil conditions. Finally, these transmissions are more often the driver’s personal preference, making recruiting and retaining good drivers easier."

If I looked it up right it costs $10,000+ to replace the transmission on one of those. And as a work truck that is something that end up getting replaced. Perhaps several times. So extending the life time might be a good idea.

Also as a thought a standard dump truck has between 10-18 gears. Probably with that many getting it right all the time is unlikely.

trønderen2-May-23 14:17

2-May-23 14:17

I guess farm tractors would be different, too. And bulldozers. And excavators. And ...

theoldfool1-May-23 12:44

theoldfool

1-May-23 12:44

My first car was fitted with a crank. Never used it though, pushing easier.

>64
Some days the dragon wins. Suck it up.

trønderen1-May-23 16:39

1-May-23 16:39

If the car is located on a flat, clean road: Maybe.

If the reason why the battery is dead is that you have just dug your car out of a meter of snow, where it has been sitting since September and the battery didn't take the cold well, then pushing the car up on the road may be quite a task!