|
Hmmmm
Your not sending 2,000,000+ e-mails all at once are you? Back in the 1990's I was administering some high-load Unix servers and when I performed daily/weekly mailings to site members I would send A-D and wait 15 minutes then send E-H and so forth to avoid being blacklisted. When you send millions of e-mails all at once there is no way for the recieving end to distinguish a DOS attack from a legitimate mass mailing unless they have white listed the origin IP.
Unfortunately it is easy to spoof the From: e-mail address... so the only way for a systems administrator to 'white list' is to use the IP of the sending server. The addresses contained in the 'Received: from' header can also be spoofed if passing through a relay.
|
|
|
|
|
With many of the big email providers they don't block on the basis of the number of messages per hour or minute or second, but by the concurrent connections. It’s a juggling act here to try and keep our addresses clean to make sure everything gets through. To answer your question though, no we don't send out to everyone at the same time. Although, I sure would like to send them out all at once. 
Yes, Server side whitelisting goes either by domain or more often by IP. Domain and email level whitelisting is still something that needs to happen on the user end though as most places have implemented user defined whitelists. These are typically not done by IP.
modified 26-Mar-12 14:46pm.
|
|
|
|
|
Have noticed 2 comment/discussion blocks appearing for some articles. Here is an example[^].
"If you think it's expensive to hire a professional to do the job, wait until you hire an amateur." Red Adair.
nils illegitimus carborundum
me, me, me
|
|
|
|
|
Yes, for new versions of existing articles a new forum, specifically to cater to comments on changes of the article is added. There is an explanation above each discussion board that should make this clear, but if the explanation isn't there (or isn't clear) let me know.
cheers,
Chris Maunder
The Code Project | Co-founder
Microsoft C++ MVP
|
|
|
|
|
Thanks
"If you think it's expensive to hire a professional to do the job, wait until you hire an amateur." Red Adair.
nils illegitimus carborundum
me, me, me
|
|
|
|
|
Hi,
I have a problem with the following article ASP.NET MVC3 Razor With JQuery For Beginners[^]. In the edit section, the second code listing (above the picture is cut-off). If you open this link in the edit section you can see that this part of code ends with
@Html.ValidationMessageFor(model =>
there is a code after this statement but it is not generated here. When I go to the article and edit is this code is not cut-off. It seems to me that this > causes some problem where and ends the code on this position.
I have tried to remove this => and replace it with just = . In that case code is continued to the next =>.
This is very strange because I have other parts of code where I have used => but it is now cut-off there.
If you need any additional info let me know.
Thanks,
Jovan
|
|
|
|
|
Hi Jovan,
Did you already fix this on your own? It seems OK to me now. Please let me know if all is well. I suspect it was an angle bracket that was like this: >
instead of this: >
Inside pre blocks our article editor requires the latter.
Thanks,
Sean Ewington
The Code Project
|
|
|
|
|
|
Our syntax colouriser is getting scared and confused by the lambda notation inside the HTML.
I'll talk to it and calm it down.
cheers,
Chris Maunder
The Code Project | Co-founder
Microsoft C++ MVP
|
|
|
|
|
Hello everyone,
I was wondering if Code Project could support pictures, like display them in posts, that would be nice, I mean if people abuse them, there's always that "report the person and let administration ban them from Code Project or take care of it", is it a memory/storage problem for the web masters, I was wondering if any of you'll had ideas like this...
Regards,
Brandon T. H.
|
|
|
|
|
They were supported some time ago, and removed for the very reason you mentioned. Too much trouble, I guess.
|
|
|
|
|
I believe CP only supports photos and videos in articles. You can post links to pictures or videos in other forums.
[edit] If we allowed pictures in CP then anyone could post anything, offensive or not. I'm talking about elephants dancing in the sunshine, if you know what I mean. 
"the meat from that butcher is just the dogs danglies, absolutely amazing cuts of beef." - DaveAuld (2011)
"No, that is just the earthly manifestation of the Great God Retardon." - Nagy Vilmos (2011)
"It is the celestial scrotum of good luck!" - Nagy Vilmos (2011)
|
|
|
|
|
I really wish I didn't... 
Ideological Purity is no substitute for being able to stick your thumb down a pipe to stop the water
|
|
|
|
|
Yeah, my mental eyes are hurting too.
cheers,
Chris Maunder
The Code Project | Co-founder
Microsoft C++ MVP
|
|
|
|
|
Chris,
Check out my comments at the bottom of this article; Introducing Visual Studio LightSwitch[^]
Basically, if the video is playing, and your browser client space is less than ~1260px then the right hand Tower ad is over the top of the video, and doesn't go behind like the rest of the text. don't know if you can tweak the zOrder.
Cheers,
|
|
|
|
|
Could I suggest that maybe 1280 is a little too big? 
Not only from a screensize perspective, but also from the point that a smaller screensize will dramatically help member bandwidth issues in downloading the video
cheers,
Chris Maunder
The Code Project | Co-founder
Microsoft C++ MVP
|
|
|
|
|
Chris Maunder wrote: Could I suggest that maybe 1280 is a little too big?
You could suggest it........up to you, there is a forum for that
|
|
|
|
|
Dear Bob, could you please...
cheers,
Chris Maunder
The Code Project | Co-founder
Microsoft C++ MVP
|
|
|
|
|
It only just hit me that you weren't the author of that video 
Sorry - I'm wading through an avalanche of email and my brain is short circuiting this morning.
Let me...adjust.
cheers,
Chris Maunder
The Code Project | Co-founder
Microsoft C++ MVP
|
|
|
|
|
Chris Maunder wrote: It only just hit me that you weren't the author of that video
So you were having a "Magical Mystery Maunder Moment" (aka senior moment)  comes to all!
|
|
|
|
|
cheers,
Chris Maunder
The Code Project | Co-founder
Microsoft C++ MVP
|
|
|
|
|
I updated my article and removed a few files that are no longer necessary. While the new version hasn't been released, the old article still points to these files and now no longer works.
Perhaps, it would be best to copy all files over to the working, delete the files in the working, and, once the article is approved, move everything over to the 'production'.
|
|
|
|
|
I just recently used the new editor (which totally rocks) to upload a new version of my article.
After doing such, I found I was able to go and approve my own article. I would assume this isn't a desired behavior. I mean, who wouldn't approve something they just submitted. 
|
|
|
|
|
Currently we have no problem with you doing this but we are going to change this so you can't approve your own articles.
cheers,
Chris Maunder
The Code Project | Co-founder
Microsoft C++ MVP
|
|
|
|
|
Clicked on the Database link in left bar, and got this page:
<html><head>
<meta http-equiv="content-type" content="text/html; charset=UTF-8">
<title>Runtime Error</title>
<style>
body {font-family:"Verdana";font-weight:normal;font-size: .7em;color:black;}
p {font-family:"Verdana";font-weight:normal;color:black;margin-top: -5px}
b {font-family:"Verdana";font-weight:bold;color:black;margin-top: -5px}
H1 { font-family:"Verdana";font-weight:normal;font-size:18pt;color:red }
H2 { font-family:"Verdana";font-weight:normal;font-size:14pt;color:maroon }
pre {font-family:"Lucida Console";font-size: .9em}
.marker {font-weight: bold; color: black;text-decoration: none;}
.version {color: gray;}
.error {margin-bottom: 10px;}
.expandable { text-decoration:underline; font-weight:bold; color:navy; cursor:hand; }
</style>
<script src="Database.aspx_files/loader_1063.js" type="text/javascript"></script></head>
<body bgcolor="white">
<span><h1>Server Error in '/' Application.<hr color="silver" size="1" width="100%"></h1>
<h2> <i>Runtime Error</i> </h2></span>
<font face="Arial, Helvetica, Geneva, SunSans-Regular, sans-serif ">
<b> Description: </b>An application error occurred on the
server. The current custom error settings for this application prevent
the details of the application error from being viewed remotely (for
security reasons). It could, however, be viewed by browsers running on
the local server machine.
<br><br>
<b>Details:</b> To enable the details of this specific error
message to be viewable on remote machines, please create a
<customErrors> tag within a "web.config" configuration file
located in the root directory of the current web application. This
<customErrors> tag should then have its "mode" attribute set to
"Off".<br><br>
<table bgcolor="#ffffcc" width="100%">
<tbody><tr>
<td>
<code><pre>
<!-- Web.Config Configuration File -->
<configuration>
<system.web>
<customErrors mode="Off"/>
</system.web>
</configuration></pre></code>
</td>
</tr>
</tbody></table>
<br>
<b>Notes:</b> The current error page you are seeing can be
replaced by a custom error page by modifying the "defaultRedirect"
attribute of the application's <customErrors> configuration tag to
point to a custom error page URL.<br><br>
<table bgcolor="#ffffcc" width="100%">
<tbody><tr>
<td>
<code><pre>
<!-- Web.Config Configuration File -->
<configuration>
<system.web>
<customErrors mode="RemoteOnly" defaultRedirect="mycustompage.htm"/>
</system.web>
</configuration></pre></code>
</td>
</tr>
</tbody></table>
<br>
</font></body></html>[If you want the attached files stuff, I've got that too - did a FF "save page as"]
Here are some for you:
[edit: Tried again after posting this, and it's OK now. Maybe a hangover from last week's solar flare.]
Cheers,
Peter
Software rusts. Simon Stephenson, ca 1994.
|
|
|
|
General 
News 
Suggestion 
Question 
Bug 
Answer 
Joke 
Praise 
Rant 
Admin 
Submit an article or tip
